1) Cast analysis.
2) Steels with improved machinability either by higher S levels up to about 0.10 % S (including controlled sulphide morphology) or Pb additions may be available on request. In the first case, the upper limit of the Mn-content may be increased by 0.15 %.
3) Steels may be supplied with a lower Si content. In this case, alternative means of deoxidation shall be used.
4) Fe is listed as a Base element for this material, but its % value is not listed in the specification. The value shown is a calculated one.

Mechanical Properties

Tabular Data

Hide table

Save as CSV Copy To Clipboard

Dimensions	Yield Strength (lbf/ft^2)	Ultimate Tensile Strength (lbf/ft^2)	Elongation (% strain)
Thickness, ≥ 5 to ≤ 10 mm	≥ 7.94e6	1.04e7 to 1.67e7	≥ 7
Thickness, > 10 to ≤ 16 mm	≥ 7.1e6	1e7 to 1.63e7	≥ 8
Thickness, > 16 to ≤ 40 mm	≥ 5.85e6	8.98e6 to 1.52e7	≥ 9
Thickness, > 40 to ≤ 63 mm	≥ 5.01e6	7.94e6 to 1.4e7	≥ 11
Thickness, > 63 to ≤ 100 mm	≥ 4.49e6	7.1e6 to 1.25e7	≥ 12